AudioCodes Mediant 2600 - Configuring Additional DHCP Options

User's Manual 182 Document #: LTRT-42060
Mediant 2600 E-SBC
3. Click Add; the following dialog box appears:
Figure 15-2: DHCP Vendor Class Table - Add Record Dialog Box
4. Configure a VCI for the DHCP server according to the parameters described in the
table below.
5. Click Submit.
Table 15-3: DHCP Vendor Class Table Parameter Descriptions
Parameter Description
Web: Index
CLI: dhcp vendor-class <index>
[DhcpVendorClass_Index]
Defines an index number for the new table record.
Note: Each table row must be configured with a unique
index.
Web: DHCP Server Index
CLI: dhcp-server-number
[DhcpVendorClass_DhcpServerIndex]
Associates the VCI table entry with a DHCP server that
you configured in ''Configuring the DHCP Server'' on page
177.
Note: Currently, only one DHCP server (Index 0) can be
configured and therefore, this parameter is always set at 0.
Web: Vendor Class Identifier
CLI: vendor-class
[DhcpVendorClass_VendorClassId]
Defines the value of the VCI DHCP Option 60.
The valid value is a string of up to 80 characters. By
default, no value is defined.
15.1.3 Configuring Additional DHCP Options
The DHCP Option table lets you configure up to 10 additional DHCP Options that the
DHCP server can use to service the DHCP client. These DHCP Options are included in the
DHCPOffer response sent by the DHCP server.
The following procedure describes how to configure DHCP Options in the Web interface.
You can also configure this using the table ini file parameter, DhcpOption or CLI command,
configure voip > dhcp option.
Note: The additional DHCP Options configured in the DHCP Option table override the
default ones, which are configured in the DHCP Servers table. In other words, if you
configure Option 67 in the DHCP Option table, the device uses the value configured
in the DHCP Option table instead of the value configured in the DHCP Servers table.
 To configure DHCP Options:
1. Open the DHCP Servers page (Configuration tab > VoIP menu > Services > DHCP
Severs).
2. In the DHCP Servers table, select the row of the desired DHCP server for which you
want to configure additional DHCP Options, and then click the DHCP Option Table
link located at the bottom of the page; the DHCP Option Table page opens.