AudioCodes Mediant 2600 - General SIP Parameters

Version 6.8 589 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
Parameter Description
Remote Media Subnet Table
Web: Remote Media
Subnet
EMS: Remote Media
Subnet
CLI: configure voip > voip-
network realm
remotemediasubnet
[SubRealm]
This table parameter defines Remote Media Subnets.
The format of the ini file table parameter is as follows:
[RemoteMediaSubnet]
FORMAT RemoteMediaSubnet_Index = RemoteMediaSubnet_Realm,
RemoteMediaSubnet_RemoteMediaSubnetIndex,
RemoteMediaSubnet_RemoteMediaSubnetName,
RemoteMediaSubnet_PrefixLength,
RemoteMediaSubnet_AddressFamily,
RemoteMediaSubnet_DstIPAddress,
RemoteMediaSubnet_QOEProfileName,
RemoteMediaSubnet_BWProfileName;
[\RemoteMediaSubnet]
For a detailed description of this table, see ''Configuring Remote Media
Subnets'' on page 251.
43.7 General SIP Parameters
The general SIP parameters are described in the table below.
Table 43-31: General SIP Parameters
Parameter Description
Web: Send reject on
overload
CLI: configure voip/sip-
definition advanced-
settings/reject-on-ovrld
[SendRejectOnOverload
]
Disables the sending of SIP 503 (Service Unavailable) responses upon
receipt of new SIP dialog-initiating requests when the device's CPU is
overloaded and thus, unable to accept and process new SIP messages.
 [0] Disable = No SIP 503 response is sent when CPU overloaded.
 [1] Enable (default) = SIP 503 response is sent when CPU
overloaded.
Note: Even if this parameter is disabled (i.e., 503 is not sent), the device
still discards new SIP dialog-initiating requests when the CPU is
overloaded.
Web: SIP 408 Response
upon non-INVITE
CLI: enbl-non-inv-408
[EnableNonInvite408Re
ply]
Enables the device to send SIP 408 responses (Request Timeout) upon
receipt of non-
INVITE transactions. Disabling this response complies with
RFC 4320/4321. By default, and in certain circumstances such as a
timeout expiry, the device sends a SIP 408 Request Timeout in response
to non-INVITE requests (e.g., REGISTER).
 [0] Disable = SIP 408 response is not sent upon receipt of non-
INVITE messages (to comply with RFC 4320).
 [1] Enable = (Default) SIP 408 response is sent upon receipt of non-
INVITE messages, if necessary.
Web: SIP Remote Reset
CLI: sip-remote-reset
[EnableSIPRemoteReset
]
Enables a specific device action upon the receipt of a SIP NOTIFY
request, where the action depends on the value received in the Event
header.
 [0] Disable (default)
 [1] Enable
The action depends on the Event header value:
 'check-sync;reboot=false': triggers the regular Automatic Update
feature (if Automatic Update has been enabled on the device)