Version 6.8 117 Mediant 2600 E-SBC
User's Manual 12. Network
3. The NTP applications remain with their default application types.
12.4.3.2 VoIP Interface per Application Type
This example describes the configuration of three VoIP interfaces; one for each application
type:
1. Interface table: Configured with three interfaces, each for a different application type,
i.e., one for OAMP, one for Call Control, and one for RTP Media, and each with a
different VLAN ID and default gateway:
Table 12-7: Example of VoIP Interfaces per Application Type in Interface Table
Index
Application
Type
Interface
Mode
IP Address
Prefix
Length
Default
Gateway
Device
Interface
Name
0 OAMP IPv4
Manual
192.168.0.2 16 192.168.0.1 1 ManagementIF
1 Control IPv4
Manual
200.200.85.14
24 200.200.85.1
200 myControlIF
2 Media IPv4
Manual
211.211.85.14
24 211.211.85.1
211 myMediaIF
2. Static Route table: A routing rule is required to allow remote management from a
host in 176.85.49.0 / 24:
Table 12-8: Example Static Route Table
Destination Prefix Length Gateway
176.85.49.0 24 192.168.11.1
3. All other parameters are set to their respective default values. The NTP application
remains with its default application types.
12.4.3.3 VoIP Interfaces for Combined Application Types
This example describes the configuration of multiple interfaces for the following
applications:
One interface for the OAMP application.
Interfaces for Call Control and Media applications, where two of them are IPv4
interfaces and one is an IPv6 interface.
1. Interface table:
Table 12-9: Example of VoIP Interfaces of Combined Application Types in Interface Table
Inde
x
Applicatio
n Type
Interfac
e Mode
IP Address
Prefix
Lengt
h
Default
Gateway
Underlyin
g Device
Interface
Name
0 OAMP IPv4
Manual
192.168.0.2 16 192.168.0.1 1 Mgmt
1 Media &
Control
IPv4
Manual
200.200.85.14 24 200.200.85.
1
201 MediaCntrl1
2 Media & IPv4 200.200.86.14 24 200.200.86. 202 MediaCntrl2
To Next Page
Loading...
