Version 6.8 533 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
43 Configuration Parameters Reference
The device's configuration parameters, default values, and their descriptions are
documented in this section.
Note: Parameters and values enclosed in square brackets [...] represent the ini file
parameters and their enumeration values.
43.1 Management Parameters
This section describes the device's management-related parameters.
43.1.1 General Parameters
The general management parameters are described in the table below.
Table 43-1: General Management Parameters
Parameter Description
Web: Web and Telnet
Access List Table
EMS: Web Access
Addresses
[WebAccessList_x]
This table configures up to ten IP addresses that are permitted to
access the device's Web interface and Telnet interfaces. Access from
an undefined IP address is denied. When no IP addresses are defined
in this table, this security feature is inactive (i.e., the device can be
accessed from any IP address).
The default is 0.0.0.0 (i.e., the device can be accessed from any IP
address).
For example:
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
For a description of this parameter, see ''Configuring Web and Telnet
Access List'' on page 60.
[CustomerSN] Defines a serial number (S/N) for the device.
Note: The device's original S/N is automatically added at the end of the
configured S/N. For example, if the original S/N is 8906721 and the
configured S/N is "abc123", the resultant S/N is "abc1238906721".
43.1.2 Web Parameters
The Web parameters are described in the table below.
Table 43-2: Web Parameters
Parameter Description
Web: Enable web access from all
interfaces
CLI: web-access-from-all-interfaces
[EnableWebAccessFromAllInterface
s]
Enables Web access from any of the device's IP network
interfaces. This feature applies to HTTP and HTTPS protocols.
[0] = (Default) Disable – Web access is only through the
OAMP interface.
[1] = Enable - Web access is through any network
To Next Page
Loading...
