AudioCodes Mediant 2600 User Manual

User's Manual 534 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
interface.
Note: For the parameter to take effect, a device reset is
required.
Web: Password Change Interval
[WebUserPassChangeInterval]
Defines the duration (in minutes) of the validity of Web login
passwords. When this duration expires, the password of the
Web user must be changed.
The valid value is 0 to 100000, where 0 means that the
password is always valid. The default is 1140.
Note: This parameter is applicable only when using the Web
Users table, where the default value of the 'Password Age'
parameter in the Web Users table inherits this parameter's
value.
Web: User Inactivity Timer
[UserInactivityTimer]
Defines the duration (in days) for which a user has not logged
in to the Web interface, after which the status of the user
becomes inactive and can no longer access the Web
interface. These users can only log in to the Web interface if
their status is changed (to New or Valid) by a System
Administrator or Master user.
The valid value is 0 to 10000, where 0 means inactive. The
default is 90.
Note: This parameter is applicable only when using the Web
Users table.
Web: Session Timeout
[WebSessionTimeout]
Defines the duration (in minutes) of inactivity of a logged-in
user in the Web interface, after which the the user is
automatically logged off the Web session. In other words, the
session expires when the user has not performed any
operations (activities) in the Web interface for the configured
duration.
The valid value is 0-100000, where 0 means no timeout. The
default is 15.
Note: You can also configure the functionality per user in the
Web Users table (see Advanced User Accounts Configuration
on page 54) which overrides this global setting
Web: Deny Access On Fail Count
[DenyAccessOnFailCount]
Defines the maximum number of failed login attempts, after
which the requesting IP address is blocked.
The valid value range is 0 to 10. The values 0 and 1 mean
immediate block. The default is 3.
Web: Deny Authentication Timer
EMS: WEB Deny Authentication
Timer
[DenyAuthenticationTimer]
Defines the duration (in seconds) for which login to the Web
interface is denied from a specific IP address (for all users)
when the number of failed login attempts has exceeded the
maximum. This maximum is defined by the
DenyAccessOnFailCount parameter. Only after this time
expires can users attempt to login from this same IP address.
The valid value is 0 to 100000, where 0 means that login is not
denied regardless of number of failed login attempts. The
default is 60.
Web: Display Login Information
[DisplayLoginInformation]
Enables display of user's login information on each successful
login attempt.
 [0] = Disable (default)
 [1] = Enable

AudioCodes Mediant 2600 Specifications

General

Brand	AudioCodes
Model	Mediant 2600
Category	Controller
Language	English