AudioCodes Mediant 2600 - Multiple Voip Network Interfaces and VLAN Parameters; Routing Parameters

Version 6.8 549 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
43.2.2 Multiple VoIP Network Interfaces and VLAN Parameters
The IP network interfaces and VLAN parameters are described in the table below.
Table 43-10: IP Network Interfaces and VLAN Parameters
Parameter Description
Interface Table
Web: Interface Table
EMS: IP Interface Settings
CLI: configure voip >
interface network-if display
[InterfaceTable]
This table parameter configures the Interface table.
The format of the ini file table parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index = InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress,
InterfaceTable_PrefixLength, InterfaceTable_Gateway,
InterfaceTable_VlanID, InterfaceTable_InterfaceName,
InterfaceTable_PrimaryDNSServerIPAddress,
InterfaceTable_SecondaryDNSServerIPAddress,
InterfaceTable_UnderlyingDevice;
[\InterfaceTable]
For a detailed description of this table, see ''Configuring IP Network
Interfaces'' on page 112.
Note: For this parameter to take effect, a device reset is required.
[EnableNTPasOAM]
Defines the application type for Network Time Protocol (NTP) services.
 [1] = OAMP (default)
 [0] = Control
Note: For this parameter to take effect, a device reset is required.
43.2.3 Routing Parameters
The IP network routing parameters are described in the table below.
Table 43-11: IP Network Routing Parameters
Parameter Description
Web: Send ICMP
Unreachable Messages
[DisableICMPUnreachable]
Enables sending of ICMP Unreachable messages.
 [0] Enable = (Default) Device sends these messages.
 [1] Disable = Device does not send these messages.
Web: Send and Receive
ICMP Redirect Messages
[DisableICMPRedirects]
Enables sending and receiving of ICMP Redirect messages.
 [0] Enable = (Default) Device sends and accepts these messages.
 [1] Disable = Device rejects these messages and also does not send
them.
Static Route Table
Web/EMS: Static Route
Table
CLI: configure voip > static
[StaticRouteTable]
Defines up to 30 static IP routes for the device. The format of the ini file
table parameter is as follows:
[ StaticRouteTable ]
FORMAT StaticRouteTable_Index = StaticRouteTable_DeviceName,
StaticRouteTable_Destination, StaticRouteTable_PrefixLength,
StaticRouteTable_Gateway, StaticRouteTable_Description;
[ \StaticRouteTable ]
See also ''Configuring Static IP Routes'' on page 119.