AudioCodes Mediant 2600 User Manual

Version 6.8 521 Mediant 2600 E-SBC
User's Manual 41. Testing SIP Signaling Calls
41.2 Starting and Stopping Test Calls
The following procedure describes how to start, stop, and restart test calls.
 To start, stop, and restart a test call:
1. In the Test Call table, select the required test call entry; the Actions button appears
above the table.
2. From the Actions drop-down list, choose the required command:
• Dial: starts the test call (this action is applicable only if the test call party is the
caller).
• Drop Call: stops the test call.
• Restart: ends all established calls and then starts the test call session again.
The status of the test call is displayed in the 'Test Status' field of the Test Call table:

"Idle": test call is not active.

"Scheduled": test call is planned to run (according to 'Schedule Interval' parameter
settings)

"Running": test call has been started (i.e., the Dial command was clicked)

"Receiving": test call has been automatically activated by calls received for the test
call endpoint from the remote endpoint (when all these calls end, the status returns to
"Idle")

"Terminating": test call is in the process of terminating the currently established calls
(this occurs if the Drop Call command is clicked to stop the test)

"Done": test call has been successfully completed (or was prematurely stopped by
clicking the Drop Call command)
A more detailed description of this field is displayed below the table when you click the
Show/Hide button (see ''Viewing Test Call Statistics'' on page 521).
41.3 Viewing Test Call Statistics
In addition to viewing a brief status description of the test call in the 'Test Status' field (as
described in ''Starting, Stopping and Restarting Test Calls'' on page 521), you can also
view a more detailed status description which includes test call statistics.
 To view statistics of a test call:
1. Open the Test Call Table page (Configuration tab > System menu > Test Call >
Test Call Table).
2. Select the test call table entry whose call statistics you want to view.

AudioCodes Mediant 2600 Specifications

General

Brand	AudioCodes
Model	Mediant 2600
Category	Controller
Language	English