AudioCodes Mediant 2600 - Basic User Accounts Configuration

Version 6.8 53 Mediant 2600 E-SBC
User's Manual 6. Web-Based Management
6.3.1 Basic User Accounts Configuration
This section describes basic Web user account configuration. This is relevant only if the
two default, pre-configured Web user accounts--Security Administrator ("Admin") and
Monitor ("User")--are sufficient for your management scheme.
The Web user account parameters that can be modified depends on the access level of the
currently logged-in Web user:
Table 6-10: Allowed Modifications per Web User Level
Logged-in User Web User Level Allowed Modifications
Security
Administrator
(Default) Security Administrator Username and password
Monitor Username, password, and access level
Monitor
(Default) Security Administrator None
Monitor Username and password
Notes:
• The username and password can be a string of up to 19 characters and are case-
sensitive.
• When only the basic user accounts are being used, up to two users can be
concurrently logged in to the Web interface, and they can be the same user.
 To configure the two pre-configured Web user accounts:
1. Open the Web User Accounts page (Configuration tab > System menu > Web User
Accounts). If you are logged in as Security Administrator, both Web user accounts
are displayed (as shown below). If you are logged in with the second user account,
only the details of this user account are displayed.
Figure 6-16: Web User Accounts Page (for Users with 'Security Administrator' Privileges)