Version 6.8 101 Mediant 2600 E-SBC
User's Manual 11. Date and Time
11.3 Configuring Daylight Saving Time
You can apply daylight saving time (DST) to the date and time of the device. DST defines a
date range in the year (summer) where the time is brought forward so that people can
experience more daylight. DST applies an offset of up to 60 minutes (default) to the local
time. For example, Germany Berlin has DST from 30 March to 26 October, where the time
is brought forward by an hour (e.g., 02:00 to 03:00 on 30 March). Therefore, you would
configure the DST offset to 60 minutes (one hour).
To configure DST using the Web interface:
1. Open the Application Settings page (Configuration tab > System menu >
Application Settings).
2. Scroll down to the 'Day Light Saving Time' group:
Figure 11-3: Configuring DST
3. From the 'Day Light Saving Time' (DayLightSavingTimeEnable) drop-down list, select
Enable.
4. From the 'DST Mode' drop-down list, select the range type for configuring the start and
end dates for DST:
• Day of year: The range is configured by exact date (day number of month), for
example, from March 30 to October 30. If 'DST Mode' is set to Day of year, in the
'Start Time' (DayLightSavingTimeStart) and 'End Time' (DayLightSavingTimeEnd)
drop-down lists, configure the period for which DST is relevant.
• Day of month: The range is configured by month and day type, for example,
from the last Sunday of March to the last Sunday of October. If 'DST Mode' is set
to Day of month, in the 'Day of Month Start' and 'Day of Month End' drop-down
lists, configure the period for which DST is relevant.
5. In the 'Offset' (DayLightSavingTimeOffset) field, configure the DST offset in minutes.
6. If the current date falls within the DST period, verify that it has been successful applied
to the device's current date and time. You can view the device's date and time in the
Regional Settings page (see 'Configuring Date and Time Manually' on page 99).
To Next Page
Loading...
