User's Manual 468 Document #: LTRT-42060
Mediant 2600 E-SBC
32.2 Restoring Defaults using an ini File
You can restore the device to factory default settings by loading an empty ini file to the
device. This is done using the Web interface's Configuration File page (see ''Backing Up
and Loading Configuration File'' on page 449). If the ini file does include content (e.g.,
parameters), ensure that they are on lines beginning with comment signs (i.e., semicolons
";") so that the device ignores them.
Note: The only settings that are not restored to default are the management (OAMP)
LAN IP address and the Web interface's login user name and password.
To Next Page
Loading...
