User's Manual 482 Document #: LTRT-42060
Mediant 2600 E-SBC
To view the status of static IP routing:
Open the IP Routing Status Table page (Status & Diagnostics tab > VoIP Status
menu >Static Route Status).
Figure 37-1: IP Routing Status Table Page
37.4 Viewing Registered Users
You can view SBC users listed in the device's Users Registration database. The list shows
each Address of Record (AOR) and its corresponding contact. The contact's registration
status is also shown:
"Active status:1" indicates that the contact has been successfully registered and thus,
calls can be routed to it.
"Active status:0" indicates that the device has recently received a REGISTER request
from the contact, but the contact has yet to be registered. The device removes the
contact from the database if no response is received within a few seconds from the
proxy/registrar server.
An AOR is a SIP or SIPS URI that points to a domain with a location service that can map
the URI to another URI (contact) where the user might be available. A contact is a SIP URI
that can be used to contact that specific instance of the user agent for subsequent
requests.
To view registered SBC users in the Users Registration database:
Web: SAS/SBC Registered Users page (Status & Diagnostics tab > VoIP Status
menu > SAS/SBC Registered Users).
Figure 37-2: SAS/SBC Registered Users Page
CLI:
• SBC users:
# show voip register db sbc list
• SBC contacts of a specified AOR:
# show voip register db sbc user <Address Of Record>
To Next Page
Loading...
