AudioCodes Mediant 2600 - Coder Parameters

Version 6.8 609 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
Parameter Description
Answer Detector (AD) Parameters
Web: Enable Answer
Detector
[EnableAnswerDetector]
Currently, not supported.
Web: Answer Detector
Activity Delay
CLI: answer-detector-
activativity-delay
[AnswerDetectorActivityD
elay]
Defines the time (in 100-msec resolution) between activating the
Answer Detector and the time that the detector actually starts to
operate.
The valid range is 0 to 1023. The default is 0.
Web: Answer Detector
Silence Time
[AnswerDetectorSilenceTi
me]
Currently, not supported.
Web: Answer Detector
Redirection
[AnswerDetectorRedirecti
on]
Currently, not supported.
Web: Answer Detector
Sensitivity
EMS: Sensitivity
CLI: answer-detector-
sensitivity
[AnswerDetectorSensitivit
y]
Defines the Answer Detector sensitivity.
The range is 0 (most sensitive) to 2 (least sensitive). The default is 0.
43.9.2 Coder Parameters
The coder parameters are described in the table below.
Table 43-34: Coder Parameters
Parameter Description
Silk Tx Inband FEC
CLI: silk-tx-inband-fec
[SilkTxInbandFEC]
Enables forward error correction (FEC) for the SILK coder.
 [0] Disable (default)

[1]
Enable
Silk Max Average Bit Rate
CLI: silk-max-average-bitrate
[SilkMaxAverageBitRate]
Defines the maximum average bit rate for the SILK coder.
The valid value range is 5000 to 30000. The default is 16000.
Note: The SILK coder is Skype's default audio codec used for
Skype-to-Skype calls.
EMS: VBR Coder Header
Format
CLI: VBR-coder-header-format
[VBRCoderHeaderFormat]
Determines the format of the RTP header for VBR coders.
 [0] = (Default) Payload only (no header, TOC, or m-factor) -
similar to RFC 3558 Header Free format.
 [1] = Supports RFC 2658 - 1 byte for interleaving header
(always 0), TOC, no m-factor.
 [2] = Payload including TOC only, allow m-factor.

[3]
= RFC 3558 Interleave/Bundled format.