AudioCodes Mediant 2600 - LDAP Parameters

Version 6.8 633 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
Parameter Description
[SharedSecret]
RADIUS Authentication Parameters
Web: Password Local
Cache Mode
CLI: local-cache-mode
[RadiusLocalCacheMod
e]
Defines the device's mode of operation regarding the timer (configured
by the parameter RadiusLocalCacheTimeout) that determines the
validity of the username and password (verified by the RADIUS server).
 [0] Absolute Expiry Timer = When you access a Web page, the
timeout doesn't reset, instead it continues decreasing.
 [1] Reset Timer Upon Access = (Default) Upon each access to a
Web page, the timeout always resets (reverts to the initial value
configured by RadiusLocalCacheTimeout).
Web: Password Local
Cache Timeout
CLI: local-cache-timeout
[RadiusLocalCacheTime
out]
Defines the time (in seconds) the locally stored username and
password (verified by the RADIUS server) are valid. When this time
expires, the username and password become invalid and a must be re-
verified with the RADIUS server.
The valid range is 1 to 0xFFFFFF. The default is 300 (5 minutes).
 [-1] = Never expires.
 [0] = Each request requires RADIUS authentication.
Web: RADIUS VSA
Vendor ID
CLI: vsa-vendor-id
[RadiusVSAVendorID]
Defines the vendor ID that the device accepts when parsing a RADIUS
response packet.
The valid range is 0 to 0xFFFFFFFF. The default is 5003.
Web: RADIUS VSA
Access Level Attribute
CLI: vsa-access-level
[RadiusVSAAccessAttri
bute]
Defines the code that indicates the access level attribute in the Vendor
Specific Attributes (VSA) section of the received RADIUS packet.
The valid range is 0 to 255. The default is 35.
[MaxRADIUSSessions]
Defines the number of concurrent calls that can communicate with the
RADIUS server (optional).
The valid range is 0 to 240. The default is 240.
EMS: RADIUS Auth
Number of Retries
[RADIUSRetransmission
]
Defines the number of retransmission retries.
The valid range is 1 to 10. The default is 3.
[RadiusTO]
Defines the time interval (measured in seconds) that the device waits
for a response before a RADIUS retransmission is issued.
The valid range is 1 to 30. The default is 10.
43.12.2.3 LDAP Parameters
The Lightweight Directory Access Protocol (LDAP) parameters are described in the table
below.
LDAP Parameters
Parameter Description
Web: LDAP Service
CLI: configure
Enables the LDAP feature.

[0]
Disable (default)