AudioCodes Mediant 2600 - Page 632

User's Manual 632 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
[RADIUSAccServerIP]
Web: Accounting Port
CLI: accounting-port
[RADIUSAccPort]
Defines the port of the RADIUS accounting server.
The default is 1646.
Web/EMS: RADIUS
Accounting Type
CLI: radius-accounting
[RADIUSAccountingTyp
e]
Determines when the RADIUS accounting messages are sent to the
RADIUS accounting server.
 [0] At Call Release = (Default) Sent at call release only.
 [1] At Connect & Release = Sent at call connect and release.

[2]
At Setup & Release = Sent at call setup and release.
Web: AAA Indications
EMS: Indications
CLI: aaa-indications
[AAAIndications]
Determines the Authentication, Authorization and Accounting (AAA)
indications.
 [0] None = (Default) No indications.
 [3] Accounting Only = Only accounting indications are used.
General RADIUS Parameters
Web: Use RADIUS for
Web/Telnet Login
EMS: Web Use Radius
Login
CLI: enable-mgmt-login
[WebRADIUSLogin]
Enables RADIUS queries for Web and Telnet login authentication.
When enabled, logging into the device's Web and Telnet embedded
servers is done through a RADIUS server. The device communicates
with a user-defined RADIUS server and verifies the given username
and password against a remote database, in a secure manner.
 [0] Disable (default)
 [1] Enable
Notes:
 For RADIUS login authentication to function, you also need to set
the following parameters:

EnableRADIUS = 1 (Enable)

WebAuthMode = 0 (Basic Mode)
 RADIUS authentication requires HTTP basic authentication, where
the username and password are transmitted in clear text over the
network. Therefore, it's recommended to set the HTTPSOnly
parameter to 1 to force the use of HTTPS, since the transport is
encrypted.
Web: RADIUS
Authentication Server IP
Address
EMS: RADIUS Auth
Server IP
CLI: auth-server-ip
[RADIUSAuthServerIP]
Defines the IP address of the RADIUS authentication server.
Note: For this parameter to take effect, a device reset is required.
Web: RADIUS
Authentication Server Port
EMS: RADIUS Auth
Server Port
CLI: auth-server-port
[RADIUSAuthPort]
Defines the port of the RADIUS authentication server.
Note: For this parameter to take effect, a device reset is required.
Web: RADIUS Shared
Secret
EMS: RADIUS Auth
Server Secret
CLI: shared-secret
Defines the 'secret' used to authenticate the device to the RADIUS
server. This should be a cryptically strong password.