AudioCodes Mediant 2600 - Assigning NTP Services to Application Types; Multiple Interface Table Configuration Summary and Guidelines

Version 6.8 115 Mediant 2600 E-SBC
User's Manual 12. Network
Parameter Description
The prefix length for IPv6 must be set to a value from 0 to 64.
Web/EMS: Default Gateway
CLI: gateway
[InterfaceTable_Gateway]
Defines the IP address of the default gateway for the interface.
When traffic is sent from this interface to an unknown
destination (i.e., not in the same subnet and not defined for any
static routing rule), it is forwarded to this default gateway.
Web/EMS: Interface Name
CLI: name
[InterfaceTable_InterfaceName]
Defines a name for the interface. This name is used in various
configuration tables to associate the network interface with
other configuration entities such as Media Realms. It is also
displayed in management interfaces (Web, CLI, and SNMP) for
clarity where it has no functional use.
The valid value is a string of up to 16 characters.
Web/EMS: Primary DNS
CLI: primary-dns
[InterfaceTable_PrimaryDNSServ
erIPAddress]
(Optional) Defines the primary DNS server's IP address (in
dotted-decimal notation), which is used for translating domain
names into IP addresses for the interface.
By default, no IP address is defined.
Web/EMS: Secondary DNS
CLI: secondary-dns
[InterfaceTable_SecondaryDNSS
erverIPAddress]
(Optional) Defines the secondary DNS server's IP address (in
dotted-decimal notation), which is used for translating domain
names into IP addresses for the interface.
By default, no IP address is defined.
Underlying Device
CLI: underlying-dev
[InterfaceTable_UnderlyingDevice]
Assigns an Ethernet Device to the IP interface. An Ethernet
Device is a VLAN ID associated with a physical Ethernet port
(Ethernet Group). To configure Ethernet Devices, see
Configuring Underlying Ethernet Devices on page 110.
12.4.1 Assigning NTP Services to Application Types
You can associate the Network Time Protocol (NTP) application with the OAMP or Control
application type. This is done using the EnableNTPasOAM ini file parameter.
12.4.2 Multiple Interface Table Configuration Summary and Guidelines
The Interface table configuration must adhere to the following rules:

Multiple Control and Media interfaces can be configured with overlapping IP
addresses and subnets.

The prefix length replaces the dotted-decimal subnet mask presentation and must
have a value of 0-30 for IPv4 addresses and a value of 0-64 for IPv6 addresses.

One OAMP interface must be configured and this must be an IPv4 address. This
OAMP interface can be combined with Media and Control.

At least one Control interface must be configured.

At least one Media interface must be configured.

Multiple Media and/or Control interfaces can be configured with an IPv6 address.