AudioCodes Mediant 2600 User Manual

User's Manual 554 Document #: LTRT-42060
Mediant 2600 E-SBC
43.2.7 DHCP Parameters
The Dynamic Host Control Protocol (DHCP) parameters are described in the table below.
Table 43-15: DHCP Parameters
Parameter Description
Web: Enable DHCP
EMS: DHCP Enable
[DHCPEnable]
Enables DHCP client functionality.
 [0] Disable (default)
 [1] Enable
Notes:
 For this parameter to take effect, a device reset is required.
 For a detailed description of DHCP, see ''DHCP-based
Configuration Server'' on page 451.
 This parameter is a "hidden" parameter. Once defined and
saved to flash memory, its value doesn't revert to default
even if the parameter doesn't appear in the ini file.
EMS: DHCP Speed Factor
[DHCPSpeedFactor]
Defines the device's DHCP renewal speed for a leased IP
address from a DHCP server.
 [0] = Disable
 [1] = (Default) Normal
 [2] to [10] = Fast
When set to 0, the DHCP lease renewal is disabled. Otherwise,
the renewal time is divided by this factor. Some DHCP-enabled
routers perform better when set to 4.
Note: For this parameter to take effect, a device reset is
required.
DHCP Servers Table
Web: DHCP Servers Table
CLI: configure voip > dhcp
server <index>
[DhcpServer]
Defines the device's embedded DHCP server.
The format of the ini file table parameter is as follows:
[ DhcpServer ]
FORMAT DhcpServer_Index = DhcpServer_InterfaceName,
DhcpServer_StartIPAddress, DhcpServer_EndIPAddress,
DhcpServer_SubnetMask, DhcpServer_LeaseTime,
DhcpServer_DNSServer1, DhcpServer_DNSServer2,
DhcpServer_NetbiosNameServer,
DhcpServer_NetbiosNodeType, DhcpServer_NTPServer1,
DhcpServer_NTPServer2, DhcpServer_TimeOffset,
DhcpServer_TftpServer, DhcpServer_BootFileName,
DhcpServer_ExpandBootfileName,
DhcpServer_OverrideRouter, DhcpServer_SipServer,
DhcpServer_SipServerType;
[ \DhcpServer ]
For a detailed description of this table, see Configuring the
Device's DHCP Server on page 177.
DHCP Vendor Class Table
Web: DHCP Vendor Class
table
CLI: configure voip > dhcp
vendor-class
[DhcpVendorClass]
Defines Vendor Class Identifier (VCI) names (DHCP Option 60)
for the device's DHCP server. Only if the DHCPDiscover
request message, received from the DHCP client, contains this
value does the device provide DHCP services.
The format of the ini file table parameter is as follows:

AudioCodes Mediant 2600 Specifications

General

Brand	AudioCodes
Model	Mediant 2600
Category	Controller
Language	English