AudioCodes Mediant 2600 - Networking Parameters; Ethernet Parameters

User's Manual 548 Document #: LTRT-42060
Mediant 2600 E-SBC
43.2 Networking Parameters
This subsection describes the device's networking parameters.
43.2.1 Ethernet Parameters
The Ethernet parameters are described in the table below.
Table 43-9: Ethernet Parameters
Parameter Description
Physical Ports Settings Table
Web: Physical Ports
Settings
CLI: configure
voip/physical-port
[PhysicalPortsTable]
This table parameter configures the physical Ethernet ports
The format of this parameter is as follows:
[ PhysicalPortsTable ]
FORMAT PhysicalPortsTable_Index = PhysicalPortsTable_Port,
PhysicalPortsTable_Mode, PhysicalPortsTable_NativeVlan,
PhysicalPortsTable_SpeedDuplex, PhysicalPortsTable_PortDescription,
PhysicalPortsTable_GroupMember, PhysicalPortsTable_GroupStatus;
[ \PhysicalPortsTable ]
For example:
PhysicalPortsTable 0 = GE_4_1, 1, 1, 4, "User Port #0", GROUP_1,
Active;
PhysicalPortsTable 1 = GE_4_2, 1, 1, 4, "User Port #1", GROUP_1,
Redundant;
Note: For a description of this parameter, see Configuring Physical
Ethernet Ports on page 105.
Ethernet Group Settings Table
Web: Ethernet Group
Settings
CLI: configure voip/ether-
group
[EtherGroupTable]
Defines the transmit (Tx) and receive (Rx) settings for the Ethernet port
groups. The format of this parameter is as follows:
[EtherGroupTable]
FORMAT EtherGroupTable_Index = EtherGroupTable_Group,
EtherGroupTable_Mode, EtherGroupTable_Member1,
EtherGroupTable_Member2;
[\EtherGroupTable]
For a description of this parameter, see Configuring Ethernet Port
Groups on page 107.
Note: For this parameter to take effect, a device reset is required.