AudioCodes Mediant 2600 User Manual

Version 6.8 565 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
Parameter Description
[RAILoopTime]
Defines the time interval (in seconds) that the device periodically checks
call resource availability.
The valid range is 1 to 200. The default is 10.
43.3.5 HA Ping Parameters
The High Availability (HA) Ping parameters are described in the table below.
Table 43-21: HA Ping Parameters
Parameter Description
HA Device Name
configure system >
high-availability >
unit-id-name
[HAUnitIdName]
Defines a name for the device, which is displayed on the Home page to
indicate the active device.
The valid value is a string of up to 128 characters. The default value is
"Device 1" for the active device and "Device 2" for the redundant device.
HA Remote Address
configure system >
high-availability >
remote-address
[HARemoteAddress]
Defines the Maintenance interface address of the redundant device in
the HA system.
By default, no value is defined.
HA Revertive
configure system >
high-availability >
revertive-mode
[HARevertiveEnabled]
Enables HA switchover based on HA priority.
 [0] Disable (default) = A switchover over to the redundant device is
done only if a failure occurs in the currently active device.
 [1] Enable = A switchover over to the redundant device is done if a
failure occurs in the currently active device. However, a switchover to
the device with the highest priority (configured by the HAPriority
parameter) occurs whenever the device recovers from a failure.
Therefore, whenever possible, the highest priority device is the active
one.
For more information on the HA switchover mechansim, see Device
Switchover upon Failure on page 404.
HA Priority
configure system >
high-availability >
priority
[HAPriority]
Defines the priority of the device used in the HA Revertive mechanism.
The valid value is 1 (lowest priority) to 10 (highest priority). The default is
5.
Note:
 The parameter is applicable only if you configure the 'HA Revertive'
parameter to Enable.
 You must configure each device in the HA system with different
parameter values (priorities).
HA Monitoring Parameters
Web: HA Network
Reachability
[HAPingEnabled]
Enables the pinging of an active IP network destination in HA mode to
test reachability from one of the device's IP network interfaces. If no
reply is received from a ping and the previous ping was successful, a
switchover occurs to the redundant device.
 [0] Disabled (default)

[1]
Enabled

AudioCodes Mediant 2600 Specifications

General

Brand	AudioCodes
Model	Mediant 2600
Category	Controller
Language	English