User's Manual 64 Document #: LTRT-42060
Mediant 2600 E-SBC
Command Description
exclude <word> – filter lines which does not contain <word>
grep <options> - filter lines according to grep common Unix utility options
egrep <options> - filter lines according to egrep common Unix utility options
begin <word> – filter (print) lines which begins with <word>
between <word1> <word2> – filter (print) lines which are placed between
<word1> and <word2>
count – show the output’s line count
Example:
# show system version | grep Number
;Serial Number: 2239835;Slot Number: 1
7.1.4 Configuring Tables in CLI
Throughout the CLI, many configuration elements are in table format, where each table row
is represented by an index number. When you add a new row to a table, the device
automatically assigns it the next consecutive, available index number. You can also specify
an index number, if required. When you add a new table row, the device accesses the
row's configuration mode.
Table rows are added using the new command:
# <table name> new
For example, if three rows are configured in the Account table (account-0, account-1, and
account-2) and a new entry is subsequently added, account-3 is automatically created and
its configuration mode is accessed:
(config-voip)# sip-definition account new
(account-3)#
You can also add a new table row to any specific index number, even if a row has already
been configured for that index number. The row that was previously assigned that index
number is subsequently incremented to the next index number, as well as all the index
rows listed further down in the table.
To add a new table row to a specific index number, use the insert command:
# <table name> <index> insert
For example, if three rows are configured in the Account table (account-0, account-1, and
account-2) and a new row is subsequently added with index 1, the previous account-1
becomes account-2 and the previous account-2 becomes account-3, and so on. The
following command is run for this example:
(config-voip)# sip-definition account 1 insert
Note: This behavior when inserting table rows is applicable only to tables that do not
have "child" tables (sub-tables).
To Next Page
Loading...
Need help?
General
