AudioCodes Mediant 2600 - Resource Allocation Indication Parameters

User's Manual 564 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
Web: Enable Core Dump
[EnableCoreDump]
Enables the automatic generation of a Core Dump file upon a device
crash.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is required.
Web: Core Dump Destination
IP
[CoreDumpDestIP]
Defines the IP address of the remote server where you want the
device to send the Core Dump file.
By default, no IP address is defined.
Logging Filters Table
Web: Logging Filters Table
CLI: configure system >
logging > logging-filters
[LoggingFilters]
This table parameter defines logging filtering rules for Syslog
messages and debug recordings.
The format of the ini file table parameter is:
[ LoggingFilters ]
FORMAT LoggingFilters_Index = LoggingFilters_FilterType,
LoggingFilters_Value, LoggingFilters_Syslog,
LoggingFilters_CaptureType;
[ \LoggingFilters ]
For a detailed description of this table, see ''Filtering Syslog
Messages and Debug Recordings'' on page 507.
43.3.4 Resource Allocation Indication Parameters
The Resource Allocation Indication (RAI) parameters are described in the table below.
Table 43-20: RAI Parameters
Parameter Description
[EnableRAI]
Enables Resource Available Indication (RAI) alarm generation if the
device's busy endpoints exceed a user-defined threshold, configured by
the RAIHighThreshold parameter. When enabled and the threshold is
crossed, the device sends the SNMP trap, acBoardCallResourcesAlarm.
 [0] = (Default) Disable
 [1] = Enable
Note: For this parameter to take effect, a device reset is required.
[RAIHighThreshold]
Defines the high threshold percentage of total calls that are active (busy
endpoints). When the percentage of the device's busy endpoints
exceeds this high threshold, the device sends the SNMP
acBoardCallResourcesAlarm alarm trap with a 'major' alarm status.
The range is 0 to 100. The default is 90.
Note: The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of “enabled” endpoints.
[RAILowThreshold]
Defines the low threshold percentage of total calls that are active (busy
endpoints).
When the percentage of the device's busy endpoints falls below this low
threshold, the device sends an SNMP acBoardCallResourcesAlarm
alarm trap with a 'cleared' alarm status.
The range is 0 to 100%. The default is 90%.