Version 6.8 479 Mediant 2600 E-SBC
User's Manual 36. Carrier-Grade Alarms
36 Carrier-Grade Alarms
This section describes how to view the following types of alarms:
Active alarms - see ''Viewing Active Alarms'' on page 479
Alarm history - see ''Viewing Alarm History'' on page 479
36.1 Viewing Active Alarms
The Active Alarms page displays a list of currently active alarms. You can also access this
page from the Home page (see ''Viewing the Home Page'' on page 49).
Note:
• The alarms in the table are deleted upon a device reset.
• To configure the maximum number of active alarms that can be displayed in the
table, see the ini file parameter, ActiveAlarmTableMaxSize.
• For more information on SNMP alarms, refer to the SNMP Reference Guide
document.
To view the list of active alarms:
Open the Active Alarms page (Status & Diagnostics tab > System Status menu >
Carrier-Grade Alarms > Active Alarms).
Figure 36-1: Active Alarms Page
For each alarm, the following information is provided:
Severity: severity level of the alarm:
• Critical (red)
• Major (orange)
• Minor (yellow)
Source: unit from which the alarm was raised
Description: brief explanation of the alarm
Date: date and time that the alarm was generated
You can view the next 20 alarms (if exist), by clicking the Go to page button.
36.2 Viewing Alarm History
The Alarms History page displays a list of alarms that have been raised and traps that have
been cleared.
To view the list of history alarms:
Open the Alarms History page (Status & Diagnostics tab > System Status menu >
Carrier-Grade Alarms > Alarms History).
To Next Page
Loading...
