AudioCodes Mediant 2600 - Call Setup Rules Parameters

Version 6.8 637 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
Parameter Description
CLI: configure voip >
services least-cost-routing
cost-group
[CostGroupTable]
[ CostGroupTable ]
FORMAT CostGroupTable_Index =
CostGroupTable_CostGroupName,
CostGroupTable_DefaultConnectionCost,
CostGroupTable_DefaultMinuteCost;
[ \CostGroupTable ]
For example: CostGroupTable 2 = "Local Calls", 2, 1;
Note: For a detailed description of this table, see ''Configuring Cost
Groups'' on page 226.
Web: Cost Group > Time
Band Table
EMS: Time Band
Provisioning > Time Band
CLI: configure voip >
services least-cost-routing
cost-group-time-bands
[CostGroupTimebands]
This table parameter configures time bands and associates them with
Cost Groups.
[CostGroupTimebands]
FORMAT CostGroupTimebands_TimebandIndex =
CostGroupTimebands_StartTime, CostGroupTimebands_EndTime,
CostGroupTimebands_ConnectionCost,
CostGroupTimebands_MinuteCost;
[\CostGroupTimebands]
Note: For a detailed description of this table, see ''Configuring Time
Bands for Cost Groups'' on page 227.
43.12.4 Call Setup Rules Parameters
The Call Setup Rules parameters are described in the table below.
Table 43-41: Call Setup Rules Parameters
Parameter Description
Web: Call Setup Rules
CLI: configure voip/services
call-setup-rules
[CallSetupRules]
This table parameter defines Call Setup Rules that the device runs at
call setup for LDAP-based routing and other advanced routing logic
requirements including manipulation.
[ CallSetupRules ]
FORMAT CallSetupRules_Index = CallSetupRules_RulesSetID,
CallSetupRules_AttributesToQuery, CallSetupRules_AttributesToGet,
CallSetupRules_RowRole, CallSetupRules_Condition,
CallSetupRules_ActionSubject, CallSetupRules_ActionType,
CallSetupRules_ActionValue;
[ \CallSetupRules ]
Note: For a detailed description of this table, see ''Configuring Call
Setup Rules'' on page 229.