AudioCodes Mediant 2600 - RADIUS and LDAP Parameters; General Parameters; RADIUS Parameters

Version 6.8 631 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
43.12.2 RADIUS and LDAP Parameters
43.12.2.1 General Parameters
The general RADIUS and LDAP parameters are described in the table below.
General RADIUS and LDAP Parameters
Parameter Description
Web: Use Local Users
Database
CLI: configure system >
mgmt-auth > use-local-
users-db
[MgmtUseLocalUsersDa
tabase]
Defines when the device uses its local user database (Web Users
table) for LDAP- or RADIUS-based management-user login
authentication.
 [0] When No Auth Server Defined = (Default) When no
LDAP/RADIUS server is configured (or as fallback if the server is
inaccessible).
 [1] Always = Always first verify the user's credentials in the Web
Users table, and if not found, then search the LDAP/RADIUS server.
Web: Behavior upon
Authentication Server
Timeout
CLI: configure system >
mgmt-auth > timeout-
behavior
[MgmtBehaviorOnTimeo
ut]
Defines the device's response when a connection timeout occurs with
the LDAP/RADIUS server.
 [0] Deny Access = User is denied access to the management
platform.
 [1] Verify Access Locally = (Default) Device verifies the user's
credentials in its Web Users table (local database).
Note: The parameter is applicable to LDAP- or RADIUS-based
management-user login authentication.
Web: Default Access
Level
CLI: default-access-level
[DefaultAccessLevel]
Defines the default access level for the device when the LDAP/RADIUS
response doesn't include an access level attribute for determining the
user's management access level.
The valid range is 0 to 255. The default is 200 (i.e., Security
Administrator).
Note: The parameter is applicable to LDAP- or RADIUS-based
management-user login authentication and authorization.
43.12.2.2 RADIUS Parameters
The RADIUS parameters are described in the table below.
RADIUS Parameters
Parameter Description
RADIUS Accounting Parameters
Web: Enable RADIUS
Access Control
CLI: enable
[EnableRADIUS]
Enables the RADIUS application.
 [0] Disable (Default)
 [1] Enable
Note: For this parameter to take effect, a device reset is required.
Web: Accounting Server
IP Address
CLI: accounting-server-ip
Defines the IP address of the RADIUS accounting server.