AudioCodes Mediant 2600 - 18 SIP Definitions; Configuring SIP Parameters; Configuring Registration Accounts

Version 6.8 277 Mediant 2600 E-SBC
User's Manual 18. SIP Definitions
18 SIP Definitions
This section describes configuration of SIP parameters.
18.1 Configuring SIP Parameters
Many of the stand-alone SIP parameters associated with various features can be
configured in the following pages:

SIP General Parameters page: Provides SIP parameters for configuring general SIP
features. To access this page, use the following path: Configuration tab > VoIP menu
> SIP Definitions > General Parameters.

SIP Advanced Parameters page: Provides SIP parameters for configuring advanced
SIP features. To access this page, use the following path: Configuration tab > VoIP
menu > SIP Definitions > Advanced Parameters.
For a description of these parameters, refer to the section corresponding to the feature or
see ''Configuration Parameters Reference'' on page 533.
18.2 Configuring Registration Accounts
The Account table lets you configure up to 200 Accounts. An Account defines registration
information for registering and authenticating (digest) "served" IP Groups (e.g., IP PBX)
with a "serving" IP Group (e.g., ITSP). Registration information includes a username,
password, host name (AOR), and contact user name (AOR). The device includes this
information in the REGISTER message sent to the "serving" IP Group. Up to 10 Accounts
can be configured per "served" IP Group.
A "served" IP Group can register to more than one "serving" IP Group (e.g., multiple
ITSPs). This is done by configuring multiple entries in the Account table for the same
"served" IP Group, but with different "serving" IP Groups, user name/password, host name,
and contact user values.
Note: If no match is found in the Account table for incoming or outgoing calls, the
username and password is taken from the 'UserName' and 'Password' parameters on
the Proxy & Registration page
The following procedure describes how to configure Accounts in the Web interface. You
can also configure Accounts using the table ini file parameter, Account or CLI command,
configure voip > sip-definition account.