AudioCodes Mediant 2600 - Services; SIP-Based Media Recording Parameters

User's Manual 630 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
[AGCMinGain]
Note: For this parameter to take effect, a device reset is required.
Web: AGC Maximum Gain
EMS: Maximal Gain
CLI: AGC-max-gain
[AGCMaxGain]
Defines the maximum gain (in dB) by the AGC when activated.
The range is 0 to 18. The default is 15.
Note: For this parameter to take effect, a device reset is required.
Web/EMS: Disable Fast
Adaptation
CLI: AGC-disable-fast-
adaptation
[AGCDisableFastAdaptation]
Enables the AGC Fast Adaptation mode.
 [0] = Disable (default)
 [1] = Enable
Note: For this parameter to take effect, a device reset is required.
43.12 Services
43.12.1 SIP-based Media Recording Parameters
The SIP-based media recording parameters are described in the table below.
Table 43-39: SIP-based Media Recording Parameters
Parameter Description
Web: SIP Recording Application
CLI: configure voip/services sip-
recording general-
setting/enable-sip-rec
[EnableSIPRec]
Enables the SIP-based Media Recording feature:
 [0] Disable (default)
 [1] Enable
Note: For this parameter to take effect, a device reset is required.
Web: Recording Server (SRS)
Destination Username
CLI: configure voip/services sip-
recording general-
setting/siprec-server-dest-
username
[SIPRecServerDestUsername]
Defines the SIP user part for the recording server. This user part is
added in the SIP To header of the INVITE message that the device
sends to the recording server.
The valid value is a string of up to 50 characters. By default, no
user part is defined.
SIP Recording Routing Table
Web: SIP Recording Routing
table
CLI: configure voip/services sip-
recording sip-rec-routing
[SIPRecRouting]
Defines SIP Recording Routing rules (calls to record).
The format of the ini file table parameter is as follows:
[ SIPRecRouting ]
FORMAT SIPRecRouting_Index =
SIPRecRouting_RecordedIPGroupID,
SIPRecRouting_RecordedSourcePrefix,
SIPRecRouting_RecordedDestinationPrefix,
SIPRecRouting_PeerIPGroupID,
SIPRecRouting_PeerTrunkGroupID, SIPRecRouting_Caller,
SIPRecRouting_SRSIPGroupID;
[ \SIPRecRouting ]
For a detailed description of this table, see ''Configuring SIP
Recording Routing Rules'' on page 190.