AudioCodes Mediant 2600 - IP Media Parameters

User's Manual 628 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
IPInboundManipulation_Prefix2Add,
IPInboundManipulation_Suffix2Add;
[\IPInboundManipulation]
For a detailed description of this table, see ''Configuring IP-to-IP
Inbound Manipulations'' on page 382.
IP to IP Outbound Manipulation Table
Web: IP to IP Outbound
Manipulation
EMS: IP to IP Outbound
Manipulation
CLI: configure voip > sbc
manipulations ip-outbound-
manipulation
[IPOutboundManipulation]
This table parameter configures the IP to IP Outbound
Manipulation table. This table allows you to manipulate the SIP URI
user part (source and/or destination) of the outbound SIP dialog
message. The format of the ini file table parameter is as follows:
FORMAT IPOutboundManipulation_Index =
IPOutboundManipulation_ManipulationName,
IPOutboundManipulation_IsAdditionalManipulation,
IPOutboundManipulation_SrcIPGroupID,
IPOutboundManipulation_DestIPGroupID,
IPOutboundManipulation_SrcUsernamePrefix,
IPOutboundManipulation_SrcHost,
IPOutboundManipulation_DestUsernamePrefix,
IPOutboundManipulation_DestHost,
IPOutboundManipulation_RequestType,
IPOutboundManipulation_ReRouteIPGroupID,
IPOutboundManipulation_Trigger,
IPOutboundManipulation_ManipulatedURI,
IPOutboundManipulation_RemoveFromLeft,
IPOutboundManipulation_RemoveFromRight,
IPOutboundManipulation_LeaveFromRight,
IPOutboundManipulation_Prefix2Add,
IPOutboundManipulation_Suffix2Add,
IPOutboundManipulation_PrivacyRestrictionMode;
For a detailed description of this table, see ''Configuring IP-to-IP
Outbound Manipulations'' on page 385.
43.11 IP Media Parameters
The IP media parameters are described in the table below.
Table 43-38: IP Media Parameters
Parameter Description
Web: Number of Media
Channels
EMS: Media Channels
CLI: media-channels
[MediaChannels]
Defines the maximum number of DSP channels allocated for various
functionalities such as transcoding, .
The default is 0.
Notes:
 For this parameter to take effect, a device reset is required.
 The SBC application does not require DSP channels. The SBC
application uses DSP channels only if media transcoding is
needed, where two DSP channels are used per transcoding
session.
Automatic Gain Control (AGC) Parameters
Web: Enable AGC
EMS: AGC Enable
Enables the AGC mechanism. The AGC mechanism adjusts the level
of the received signal to maintain a steady (configurable) volume level.