AudioCodes Mediant 2600 - Step 2: Configure the Second Device

Version 6.8 411 Mediant 2600 E-SBC
User's Manual 25. HA Configuration
6. Power down the device.
7. Continue to ''Step 2: Configure the Second Device'' on page 411 for configuring the
second device.
25.1.2.2 Step 2: Configure the Second Device
Once you have configured the first device for HA, you can configure the second device for
HA. As the configuration of the second device is similar to the first device, the procedure
below briefly describes each procedural step. For detailed configuration such as the path to
the Web configuration pages, refer to the section on configuring the first device (''Step 1:
Configure the First Device'' on page 409).
Note: During this stage, ensure that the first device is powered off or disconnected
from the network.
 To configure the second device for HA:
1. Connect to the device in the same way as you did with the first device.
2. Configure the same OAMP, Media, and Control interfaces as you configured for the
first device.
3. Configure a Maintenance interface for this device. The IP address must be different to
that configured for the Maintenance interface of the first device. However, the
Maintenance interfaces of the devices must be in the same subnet.
4. Configure the same Native VLAN IDs of the Ethernet Port Groups and VLAN IDs of
the network interfaces as you configured for the first device.
5. Configure the same Ethernet port Tx / Rx mode of the Ethernet Port Group used by
the Maintenance interface as you configured for the first device.
6. Configure the HA parameters in the HA Settings page (Configuration tab > System
menu > HA Settings):
a. In the 'HA Remote Address' field, enter the Maintenance IP address of the first
device.
b. (Optional) Enable the Revertive mode by setting the 'HA Revertive' field to
Enable and then setting the priority level of this second device in the 'HA Priority'
field.
7. Burn the configuration to flash without a reset.
8. Power down the device.
9. Continue to ''Step 3: Initialize HA on the Devices'' on page 412 for completing the HA
configuration.