User's Manual 536 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
acSysActionSetReset to 1).
2) Change the username and password in the
acSysWEBAccessEntry table. Use the following
format:
Username acSysWEBAccessUserName:
old/pass/new
Password acSysWEBAccessUserCode:
username/old/new
[WelcomeMessage]
Enables and defines a Welcome message that appears on the
Web Login page for logging in to the Web interface.
The format of this parameter is as follows:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text
[\WelcomeMessage]
For Example:
FORMAT WelcomeMessage_Index = WelcomeMessage_Text
WelcomeMessage 1 = "**********************************" ;
WelcomeMessage 2 = "********* This is a Welcome message
***" ;
WelcomeMessage 3 = "**********************************" ;
Notes:
 Each index row represents a line of text in the Welcome
message box. Up to 20 lines (or rows) of text can be
defined.
 The configured text message must be enclosed in double
quotation marks (i.e., "...").

If this parameter is not configured, no Welcome message is
displayed.
Web: HA Device Name
[HAUnitIdName]
Defines a name for the device, which is displayed on the
Home page to indicate the active device.
The valid value is a string of up to 128 characters. For the
default value, the device assigns either "Device 1" or "Device
2", so that active and redundant devices have different default
names.
43.1.3 Telnet Parameters
The Telnet parameters are described in the table below.
Table 43-3: Telnet Parameters
Parameter Description
Web: Embedded Telnet Server
EMS: Server Enable
CLI: telnet
[TelnetServerEnable]
Enables the device's embedded Telnet server. Telnet is disabled by
default for security.
 [0] Disable
 [1] Enable Unsecured (default)
 [2] Enable Secured
Note: Only the primary Web User Account (which has Security
Administration access level) can access the device using Telnet
To Next Page
Loading...
Need help?
General
