Version 6.8 535 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
Parameter Description
[EnableMgmtTwoFactorAuthentic
ation]
Enables Web login authentication using a third-party, smart
card.
 [0] = Disable (default)
 [1] = Enable
When enabled, the device retrieves the Web user’s login
username from the smart card, which is automatically
displayed (read-only) in the Web Login screen; the user is
then required to provide only the login password.
Typically, a TLS connection is established between the smart
card and the device’s Web interface, and a RADIUS server is
implemented to authenticate the password with the username.
Thus, this feature implements a two-factor authentication -
what the user has (the physical card) and what the user knows
(i.e., the login password).
EMS: HTTPS Port
CLI: http-port
[HTTPport]
Defines the LAN HTTP port for Web management (default is
80). To enable Web management from the LAN, configure the
desired port.
Note: For this parameter to take effect, a device reset is
required.
EMS: Disable WEB Config
[DisableWebConfig]
Determines whether the entire Web interface is read-only.
 [0] = (Default) Enables modifications of parameters.
 [1] = Web interface is read-only.
When in read-only mode, parameters can't be modified. In
addition, the following pages can't be accessed: 'Web User
Accounts', 'Certificates', 'Regional Settings', 'Maintenance
Actions' and all file-loading pages ('Load Auxiliary Files',
'Software Upgrade Wizard', and 'Configuration File').
Note: For this parameter to take effect, a device reset is
required.
[ResetWebPassword]
Enables the device to restore the default management users:
 Security Administrator user (username "Admin"; password
"Admin")
 Monitor user (username "User"; password "User")
In addition, all other users that may have been configured (in
the Web Users table) are deleted.
 [0] = (Default) Disabled. Currently configured users
(usernames and passwords) are retained.
 [1] = Enabled. Default users are restored (see description
above) and all other configured users are deleted.
Notes:
 For the parameter to take effect, a device reset is required.
 In addition to the ini file (see above), you can also restore
the default user accounts through the following
management platforms:
SNMP (restores default users and retains other
configured users:
1) Set acSysGenericINILine to
WEBPasswordControlViaSNMP = 1, and reset the
device with a flash burn (set
acSysActionSetResetControl to 1 and
To Next Page
Loading...
Need help?
General
