AudioCodes Mediant 2600 User Manual

Version 6.8 467 Mediant 2600 E-SBC
User's Manual 32. Restoring Factory Defaults
32 Restoring Factory Defaults
You can restore the device's configuration to factory defaults using one of the following
methods:

CLI (see ''Restoring Defaults using CLI'' on page 467)

Loading an empty ini file (see ''Restoring Defaults using an ini File'' on page 468)
32.1 Restoring Defaults using CLI
The device can be restored to factory defaults using CLI, as described in the procedure
below.
 To restore factory defaults using CLI:
1. Access the CLI:
a. Connect the RS-232 serial port of the device to the communication port on your
computer. For serial cabling, refer to the Hardware Installation Manual.
b. Establish serial communication with the device using a serial communication
program (such as HyperTerminal
TM
) with the following communication port
settings:
♦ Baud Rate: 115,200 bps
♦ Data Bits: 8
♦ Parity: None
♦ Stop Bits: 1
♦ Flow Control: None
2. At the CLI prompt, type the username (default is "Admin" - case sensitive), and then
press Enter:
# Username: Admin
3. At the prompt, type the password (default is "Admin" - case sensitive), and then press
Enter:
# Password: Admin
4. At the prompt, type the following, and then press Enter:
# enable
5. At the prompt, type the password again, and then press Enter:
# Password: Admin
6. At the prompt, type the following to reset the device to default settings, and then press
Enter:
# write factory

AudioCodes Mediant 2600 Specifications

General

Brand	AudioCodes
Model	Mediant 2600
Category	Controller
Language	English