SIP User's Manual 232 Document #: LTRT-12801
MP-500 MSBG
3.5.1.1.3 Configuring SNMP V3 Users
The 'SNMP V3 Settings' page allows you to configure authentication and privacy for up to
10 SNMP v3 users.
¾ To configure the SNMP v3 users:
1. Access the 'Management Settings' page, as described in ''Configuring the
Management Settings'' on page 228.
2. In the 'S
NMP V3 Table' field, click the right-pointing arrow
button; the 'SNMP V3
Settings' page appears.
Figure 3-181: SNMP V3 Setting Page
3. To add an SNMP v3 user, in the 'Add' field, enter the desired row index, and then click
Add. A new row appears.
4. Configure the SNMP V3 Setting parameters according to the table below.
5. Click the Apply button to save your changes.
6. To save the changes, refer to ''Saving Configuration'' on page 237.
Notes:
• For a description of the web interface's table command buttons (e.g.,
Duplicate and Delete), refer to ''Working with Tables'' on page 37.
• You can also configure SNMP v3 users using the ini file table parameter
SNMPUsers (refer to ''SNMP Parameters'' on page 315).
Table 3-33: SNMP V3 Users Parameters
Parameter Description
Index
[SNMPUsers_Index]
The table index.
The valid range is 0 to 9.
User Name
[SNMPUsers_Username]
Name of the SNMP v3 user. This name must be unique.
Authentication Protocol
[SNMPUsers_AuthProtocol]
Authentication protocol of the SNMP v3 user.
 [0] None (default)
 [1] MD5
 [2] SHA-1
Privacy Protocol
[SNMPUsers_PrivProtocol]
Privacy protocol of the SNMP v3 user.
 [0] None (default)
 [1] DES
 [2] 3DES
To Next Page
Loading...
Need help?
General
