Version 5.8 235 October 2009
SIP User's Manual 3. Web-Based Management
¾ To access the 'Maintenance Actions' page:
îš„ On the Navigation bar, click the Management tab, and then in the Navigation tree,
select the Management Configuration menu, and then choose the Maintenance
Actions page item.
Figure 3-184: Maintenance Actions Page
3.5.1.3.1 Resetting the Device
The 'Maintenance Actions' page allows you to remotely reset the device. In addition, before
resetting the device, you can choose the following options:
îš„ Save the device's current configuration to the device's flash memory (non-volatile).
îš„ Perform a graceful shutdown, i.e., device reset starts only after a user-defined time
expires (i.e., timeout) or after no more active traffic exists (the earliest thereof).
¾ To reset the device:
1. Open the 'Maintenance Actions' page (refer to ''Maintenance Actions'' on page 234).
2. Under the 'Reset Configuration' group, from the 'Burn To FLASH' drop-down list, select
one of the following options:
• 'Yes': The device's current configuration is saved (burned) to the flash memory
prior to reset (default).
• 'No': Resets the device without saving the current configuration to flash (discards
all unsaved modifications).
3. Under the 'Reset Configuration' group, from the 'Graceful Option' drop-down list, select
one of the following options:
• 'Yes': Reset starts only after the user-defined time in the 'Shutdown Timeout' field
(refer to Step 4) expires or after no more active traffic exists (the earliest thereof).
In addition, no new traffic is accepted.
• 'No': Reset starts regardless of traffic, and any existing traffic is terminated at
once.
4. In the 'Shutdown Timeout' field (relevant only if the 'Graceful Option' in the previous
step is set to 'Yes'), enter the time after which the device resets. Note that if no traffic
exists and the time has not yet expired, the device resets.
To Next Page
Loading...
Need help?
General
