Version 5.8 247 October 2009
SIP User's Manual 3. Web-Based Management
¾ To activate the Message Log:
1. Set the parameter 'Debug Level' (GwDebugLevel) to 6 (refer ''Configuring Advanced
Parameter'' on page 168). This pa
rameter determines the Syslog logging level in the
range 0 to 6, where 6 is the highest level.
2. Open the 'Message Log' page (Status & Diagnostics tab > Status & Diagnostics
menu > Message Log page item); the 'Message Log' page is displayed and the log is
activated.
Figure 3-192: Message Log Screen
The displayed logged messages are color coded as follows:
• Yellow - fatal error message
• Blue - recoverable error message (i.e., non-fatal error)
• Black - notice message
3. To clear the page of Syslog messages, access the 'Message Log' page again (see
Step 2); the page is cleared and new messages begin appearing.
¾ To stop the Message Log:
Close the 'Message Log' page by accessing any another page in the Web interface.
To Next Page
Loading...
