AudioCodes mediapack MP-500 User Manual

SIP User's Manual 384 Document #: LTRT-12801
MP-500 MSBG
6.9 SBC Parameters
The Session Border Control (SBC) parameters are described in the table below.
Table 6-42: SBC Parameters
Parameter Description
Web: Enable SBC Application
[EnableSBCApplication]
Enables the Session Border Control (SBC) application.
 [0] Disable (default)
 [1] Enable
Notes:
 For this parameter to take effect, a device reset is required.
 In addition to enabling this parameter, to enable SBC the
number of maximum SBC/IP-to-IP sessions must be
defined in the Feature Key.
Web: SBC Registration Time
[SBCRegistrationTime]
Configures the value (in sec) sent in the SIP Expires header
when the device replies with a SIP 200 OK in response to
Registration requests.
The default is 20.
Note: This parameter is applicable only to clients belonging to
USER-type IP Groups.
Web/EMS: WAN IP Address
[WANIPAddress]
Defines the WAN IP address for VoIP signalling applications.
The valid value is an IPv4 address in dotted-decimal notation
(xxx.xxx.xxx.xxx). The default is 0.0.0.0.
[WanMgmtHttpPort]
WAN HTTP port number. This parameter allows remote device
Web management from the WAN. To enable Web
management from the WAN, configure the desired port (e.g.,
port 80, which is the default HTTP port).
The default is 0 (i.e., no remote Web management).
Note: If the parameter HTTPSOnly is set to 1, HTTP access is
not allowed.
[WanMgmtHttpsPort]
WAN HTTPS port number. This parameter allows secure
remote device Web management from the WAN. To enable
secure Web management, configure the desired port (e.g., port
443). The default is 0 (i.e., remote Web management is not
secured).
Web: Transcoding Mode
[TranscodingMode]
Defines the voice transcoding mode (media negotiation)
between the two SBC legs for the SBC application.
 [0] Only if Required = Do not force (default). Many of the
media settings (such as gain control) are not implemented
on the voice stream. The SBC application passes packets
RTP to RTP without any processing.
 [1] Force = Force transcoding on outgoing SBC leg. The
device's SBC application interworks the media by
implementing DSP transcoding.
Note: This parameter can also be defined for an IP Profile
(using the IPProfile parameter).

AudioCodes mediapack MP-500 Specifications

General

Brand	AudioCodes
Model	mediapack MP-500
Category	Gateway
Language	English