SIP User's Manual 236 Document #: LTRT-12801
MP-500 MSBG
5. Click the Reset button; a confirmation message box appears, requesting you to
confirm.
Figure 3-185: Reset Confirmation Message Box
6. Click OK to confirm device reset; if the parameter 'Graceful Option' is set to 'Yes' (in
Step 3), the reset is delayed and a screen displaying the number of remaining calls
and time is displayed. When the device begins to reset, a message appears notifying
you of this.
Notes:
• Throughout the Web interface, parameters preceded by the lightning
symbol are not applied on-the-fly and require that you reset the device for
them to take effect.
• When you modify parameters that require a device reset, once you click
the Submit button in the relevant page, the toolbar displays the word
"Reset" (refer to ''Toolbar'' on page 28) to indicate that a device reset is
required.
• Upon reboot, the device restores the settings from its configuration file.
However, if reboot attempts fail three times consecutively, the device
resets the configuration file by restoring factory defaults before attempting
to reboot.
3.5.1.3.2 Locking and Unlocking the Device
The Lock and Unlock options allow you to lock the device so that it doesn't accept any new
incoming calls. This is useful when, for example, you are uploading new software files to
the device and you don't want any traffic to interfere with the process.
¾ To lock the device:
1. Open the 'Maintenance Actions' page (refer to ''Maintenance Actions'' on page 234).
2. Under the 'LOCK / UNLOCK' group, from the 'Graceful Option' drop-down list, select
one of the following options:
• 'Yes': The device is 'locked' only after the user-defined time in the 'Lock Timeout'
field (refer to Step 3) expires or no more active traffic exists (the earliest thereof).
In addition, no new traffic is accepted.
• 'No': The device is 'locked' regardless of traffic. Any existing traffic is terminated
immediately.
Note: These options are only available if the current status of the device is in the
Unlock state.
To Next Page
Loading...
Need help?
General
