Version 5.8 231 October 2009
SIP User's Manual 3. Web-Based Management
¾ To configure the SNMP community strings:
1. Access the 'Management Settings' page, as described in ''Configuring the
Management Settings'' on page 228.
2. In the 'SNM
P Community String' field, click the right-pointing arrow
button; the
'SNMP Community String' page appears.
Figure 3-180: SNMP Community Strings Page
3. Configure the SNMP community strings parameters according to the table below.
4. Click the Submit button to save your changes.
5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 237.
Note: To delete a community string, select the Delete check box corresponding to
the community string that you want to delete, and then click Submit.
Table 3-32: SNMP Community Strings Parameters Description
Parameter Description
Community String
Read Only [SNMPReadOnlyCommunityString_x]: Up to five
read-only community strings (up to 19 characters each). The
default string is 'public'.
Read / Write [SNMPReadWriteCommunityString_x]: Up to
five read / write community strings (up to 19 characters each).
The default string is 'private'.
Trap Community String
[SNMPTrapCommunityString]
Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
To Next Page
Loading...
