SIP User's Manual 134 Document #: LTRT-12801
MP-500 MSBG
The default attributes for the two Web user accounts are shown in the following table:
Table 3-11: Default Attributes for the Web User Accounts
Account / Attribute User Name
(Case-Sensitive)
Password
(Case-Sensitive)
Access Level
Primary Account
Admin Admin Security Administrator
Note: The Access Level cannot
be changed for this account
type.
Secondary Account
User User User Monitor
¾ To change the Web user accounts attributes:
1. Open the 'Web User Accounts' page (Configuration tab > Security Settings menu >
Web User Accounts page item).
Figure 3-130: WEB User Accounts Page (for Users with 'Security Administrator' Privileges)
Note: If you are logged into the Web interface as the Security Administrator, both Web
user accounts are displayed on the 'Web User Accounts' page (as shown above). If
you are logged in with the secondary user account, only the details of the secondary
account are displayed on the page.
2. To change the access level of the secondary account:
a. From the 'Access Level' drop-down list, select the new access level.
b. Click Change Access Level; the new access level is applied immediately.
Notes:
• The access level of the primary Web user account is 'Security
Administrator', which cannot be modified.
• The access level of the secondary account can only be modified by the
primary account user or a secondary account user with 'Security
Administrator' access level.
To Next Page
Loading...
Need help?
General
