SIP User's Manual 176 Document #: LTRT-12801
MP-500 MSBG
¾ To configure the Stand-Alone Survivability parameters:
1. Open the 'SAS Configuration' page (Configuration tab > Protocol Configuration
menu > SAS submenu > Stand Alone Survivability page item).
Figure 3-153: SAS Configuration Page
2. Configure the parameters as described in ''SIP Configuration Parameters'' on page
318.
3. Click the Submit button to apply your ch
anges.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 237.
To c
onfigure the SAS Routing table, under the SAS Routing group, click the SAS Routing
Table
button to open the 'IP2IP Routing Table' page. For a description of this table,
refer to ''Configuring the IP2IP Routing Table (SAS)'' on page 176.