Version 5.8 103 October 2009
SIP User's Manual 3. Web-Based Management
♦ Select the 'Encryption Required' check box to enable L2TP to use encryption
and then select the algorithms the server may use when encrypting data.
♦ From the 'MPPE Encryption Mode' drop-down list, select the Microsoft Point-
to-Point Encryption mode: Stateless or Stateful.
3. Under the 'Remote Address Range' group, in the 'Start IP Address' and 'End IP
Address' fields, specify the range of IP addresses that are granted by the L2TP server
to the L2TP client.
Note: The server settings must be compatible with the client settings, described in
''Configuring Network Connections'' on page 124.
3.4.3.5.4 Creating VPN Users
The procedure below describes how to add users and user groups, after clicking the Click
here to create VPN users link when configuring a PPTP server and L2TP server (refer to
''Configuring PPTP Server'' on page 100 an
d ''Configuring L2TP Server'' on page 102
respectively). You can also group users according to your preferences. The "Administrator"
user is the pre-defined default user.
¾ To add a user:
1. After clicking the Click here to create VPN users link, the following page appears:
Figure 3-85: Adding Users
To Next Page
Loading...
Need help?
General
