SIP User's Manual 314 Document #: LTRT-12801
MP-500 MSBG
6.5 RADIUS Parameters
The RADIUS parameters are described in the table below. For detailed information on the
supported RADIUS attributes, refer to ''Supported RADIUS Attributes'' on page 510.
Table 6-
20: RADIUS Parameters
Parameter Description
Web: Enable RADIUS Access
Control
[EnableRADIUS]
Determines whether the RADIUS application is enabled.
 [0] Disable = RADIUS application is disabled (default).
 [1] Enable = RADIUS application is enabled.
Note: For this parameter to take effect, a device reset is required.
Web: Accounting Server IP
Address
[RADIUSAccServerIP]
IP address of the RADIUS accounting server.
Web: Accounting Port
[RADIUSAccPort]
Port of the RADIUS accounting server.
The default value is 1646.
Web/EMS: RADIUS Accounting
Type
[RADIUSAccountingType]
Determines when the RADIUS accounting messages are sent to
the RADIUS accounting server.
 [0] At Call Release = Sent at call release only (default).
 [1] At Connect & Release = Sent at call connect and release.
 [2] At Setup & Release = Sent at call setup and release.
Web: AAA Indications
EMS: Indications
[AAAIndications]
Determines the Authentication, Authorization and Accounting
(AAA) indications.
 [0] None = No indications (default).
 [3] Accounting Only = Only accounting indications are used.
Web: Device Behavior Upon
RADIUS Timeout
[BehaviorUponRadiusTimeout]
Defines the device's response upon a RADIUS timeout.
 [0] Deny Access = Denies access.
 [1] Verify Access Locally = Checks password locally (default).
[MaxRADIUSSessions]
Number of concurrent calls that can communicate with the
RADIUS server (optional).
The valid range is 0 to 240. The default value is 240.
[RADIUSRetransmission]
Number of retransmission retries.
The valid range is 1 to 10. The default value is 3.
[RadiusTO]
Determines the time interval (measured in seconds) the device
waits for a response before a RADIUS retransmission is issued.
The valid range is 1 to 30. The default value is 10.
Web: RADIUS Authentication
Server IP Address
[RADIUSAuthServerIP]
IP address of the RADIUS authentication server.
Note: For this parameter to take effect, a device reset is required.
[RADIUSAuthPort]
RADIUS Authentication Server Port.
Note: For this parameter to take effect, a device reset is required.
Web: RADIUS Shared Secret
[SharedSecret]
'Secret' used to authenticate the device to the RADIUS server.
This should be a cryptically strong password.
To Next Page
Loading...
Need help?
General
