Version 5.8 439 October 2009
SIP User's Manual 7. Default Settings
7 Default Settings
You can restore the device's factory default settings or define your own user-defined default
settings for the device.
7.1 Restoring Factory Defaults
You can restore all or most of the device's configuration settings to default settings:
Restoring parameters to default settings, except for the device's IP address and
Web interface's login user name and password: Load to the device an empty ini file
(without any parameters or only with a semicolon (;) preceding all lines). When a
parameter is absent from a loaded ini file, the default value is assigned to that
parameter (according to the cmp file loaded to the device) and saved to the non-
volatile memory (thereby, overriding the value previously defined for that parameter).
Restoring all parameters to default settings:
• Press the device's hardware Reset button (refer to the device's Installation
Manual for more information).
• Enter the CLI Shell command RestoreFactorySettings (from the folder
CONFiguration) in a CLI session with the device.
To Next Page
Loading...
