Version 5.8 223 October 2009
SIP User's Manual 3. Web-Based Management
Table 3-30: Hunt Group Settings Parameters
Parameter Description
Hunt Group ID
[TrunkGroupSettings_TrunkGroupId]
The Hunt Group ID that you want to configure.
The valid range is 1 to 99.
Channel Select Mode
[TrunkGroupSettings_ChannelSelectMode]
The method for which IP-to-Tel calls are assigned to
channels pertaining to a Hunt Group. For a detailed
description of this parameter, refer to the global
parameter ChannelSelectMode.
 [0] By Dest Phone Number.
 [1] Cyclic Ascending (default)
 [2] Ascending
 [3] Cyclic Descending
 [4] Descending
 [5] Dest Number + Cyclic Ascending
 [6] By Source Phone Number
Registration Mode
[TrunkGroupSettings_RegistrationMode]
Registration method for the Hunt Group:
 [1] Per Gateway = Single registration for the
entire device (default). This mode is applicable
only if a default Proxy or Registrar IP are
configured, and Registration is enabled (i.e.,
parameter IsRegisterUsed is set to 1). In this
mode, the SIP URI user part in the From, To, and
Contact headers is set to the value of the global
registration parameter GWRegistrationName
(refer to ''Configuring Proxy and Registration
Parameters'' on page 147) or use
rname if
GWRegistrationName is not configured.
 [0] Per Endpoint = Each channel in the Hunt
Group registers individually. The registrations are
sent to the ServingIPGroupID if defined in the
table, otherwise to the default Proxy, and if no
default Proxy, then to the Registrar IP.
 [4] Don't Register = No registrations are sent by
endpoints pertaining to the Hunt Group. For
example, if the device is configured globally to
register all its endpoints (using the parameter
ChannelSelectMode), you can exclude some
endpoints from being registered by assigning
them to a Hunt Group and configuring the Hunt
Group registration mode to 'Don't Register'.
 [5] Per Account = Registrations are sent (or not)
to an IP Group, according to the settings in the
Account table (refer to ''Configuring the Account
Table'' on page 157).
Notes:
 To enable Hunt Group registrations, configure the
global parameter IsRegisterNeeded to 1. This is
unnecessary for 'Per Account' registration mode.
 If no mode is selected, the registration is
performed according to the global registration
To Next Page
Loading...
Need help?
General
