AudioCodes mediapack MP-500

SIP User's Manual 372 Document #: LTRT-12801
MP-500 MSBG
Parameter Description
forwarded to an IP address upon On Busy)
Notes:
 The indexing of this parameter starts at 0.
 Ensure that the Call Forward feature is enabled (default) for the
settings of this table parameter to take effect. To enable Call
Forwarding, use the parameter EnableForward.
 If the parameter FwdInfo_Destination only contains a telephone
number and a Proxy isn't used, the 'forward to' phone number
must be specified in the 'Tel to IP Routing' table (table parameter
Prefix).
 For configuring this table using the Web interface, refer to
Configuring Call Forward on page 216.
 For an explanation on using ini file table parameters, refer to
''Format of ini File Table Parameters'' on page 273.
Call Forward Reminder Ring Parameters
Notes:
 These parameters are applicable only for FXS interfaces.
 For a description of this feature, refer to Call Forward Reminder Ring on page 520.
Web: Enable NRT
Subscription
[EnableNRTSubscription]
Enables Endpoint subscription for Ring reminder event notification
feature
 [0] Disable (default)
 [1] Enable
Web: AS Subscribe IPGroupID
[ASSubscribeIPGroupID]
Defines the IP Group ID that contains the Application Server for
Subscription.
The valid value range is 1 to 8. The default is -1 (i.e., not
configured).
Web: NRT Retry Subscription
Time
[NRTRetrySubscriptionTime]
Defines the Retry period (in seconds) for Dialog subscription if a
previous request failed.
The valid value range is 10 to 7200. The default is 120.
Web: Call Forward Ring Tone
ID
[CallForwardRingToneID]
Defines the ringing tone type, played when call forward notification
is accepted.
The valid value range is 1 to 5. The default is 1.