Bernina 990 - Status Bar

Sewing
4 Sewing Screen 50
Reset
With the Reset
you can reset the saved settings of
the loaded stitch to the factory default. [}see
page70]
The function is only displayed if you have loaded a
stitch pattern with new default settings.
Combi Mode
With the Combi Mode
you can switch the Combi
Mode on and off. [}see page68]
View
With the View
function, you can adjust the view on
the Sewing Screen.
n Rotate
: Rotate the view by 90°, e.g. to make it
easier to design texts.
n Presser Foot On/Off
: Show and hide the
presser foot.
n Grid On/Off
: Show and hide the grid.
n Zoom In/Zoom Out
: Zoom the view in or out.
n Zoom Factor: Reset the view to the default.
4.1 Status Bar
The Status Bar displays the state of various functions.
Some functions can be set directly with the respective
status, e.g. the needle position, the feed dog or the
laser. For other functions, you can open the settings
with the status, e.g. the upper thread tension or the
presser foot pressure.
The color of the icon shows the current state of the
function.
n White: Default setting
n Blue: Active setting
n Yellow: Modified setting
n Red: Warning
WiFi, Time and Alarm
The WiFi
icon displays the WiFi connectivity, the
current time and alarm if active.
By tapping the icon, you open the settings for WiFi,
Time and the Alarm function. In the Settings, you can
switch the WiFi connection on or off or set up the WiFi
connection. [}see page45]
You can also set a reminder. [}see page44]
Needle Stop
The Needle Stop
icon shows the needle position
when the machine is stopped.
n
: Needle Stop Up.
n
: Needle Stop Down.
You can set the needle position to stop up or down by
toggling the icon.
Upper Thread Tension
The Upper Thread Tension
icon shows the
recommended upper thread tension for the selected
stitch.
You can modify the upper thread tension for the
selected stitch by tapping the Upper Thread Tension
icon. [}see page45]
Presser Foot
The Presser Foot
icon shows the recommended or
selected presser foot.
You can open presser foot selection by tapping the
icon. In the presser foot selection, you can select the
attached presser foot and display details about the
presser foot. [}see page41]
Presser Foot Pressure
The Presser Foot Pressure
icon shows the presser
foot pressure.
You can open and change the presser foot selection by
tapping the Presser Foot Pressure icon. [}see
page41]
Stitch Plate and Sewing Needle
The Stitch Plate and Sewing Needle
status
shows the selected needle and the attached stitch
plate. The attached stitch plate is automatically
recognized.
You can open the needle overview and select the
attached needle by tapping the icon. [}see page33]
Feed Dog
The Feed Dog
status shows the position of the
feed dog.
n Feed Dog
(white): Feed Dog is up.
n Feed Dog
(yellow): Feed Dog is down.
You can lower and raise the feed dog by tapping the
icon.
Bobbin Thread
The Bobbin Thread
status shows the fill capacity of
the lower thread bobbin.
n White: Good
n Yellow: Low or Empty
You can open the Bobbin Thread Status by tapping the
Bobbin Thread
icon. In the setting, the bobbin fill
capacity is shown and you can visualize the animation
and step-by-step instructions to insert the Bobbin Case.