Safety
SAFETY INSTRUCTIONS 7
Safety Signs on the
Machine
Sign Purpose
Attention: Close the doors, lids and
covers before operating the
machine.
Caution; moving parts. To reduce
the risk of injury, switch off the
machine before maintenance work.
Attach the covers.
Warning regarding chemical burns
Swallowing the batteries may result
in severe internal chemical burns.
Make sure that the batteries do not
fall into the hands of children.
FCC Declaration of Conformity
(For USA and Canada)
Responsible Company: BERNINA International AG,
Seestrasse 161, 8266 Steckborn, SCHWEIZ
Product Name: BERNINA 990
This device satisfies the provisions of Section15 of the
guidelines of the American Federal Communications
Commission (FCC). Operation of this device is subject
to the following conditions: (1) This device must not
cause harmful interference, and (2) this device must
accept any interference received, including interference
that may cause undesired operation.
This device has been tested and, according to the speci-
fications in Paragraph 15 of the FCC regulations, is
compliant with the limit values for a digital Class B
device. These specifications define appropriate
protection against such interference in closed rooms.
This device can generate, use and radiate HF energy.
Therefore, if not installed and used properly, it may
cause harmful interference to radio communications.
There is, however, no guarantee that interference will
not occur in certain situations. If this device does cause
harmful interference to radio or television reception,
which can be determined by turning the device off and
on, the user should try to correct the interference by
one or more of the following measures:
n Reorient the antenna or set it up at a different
location.
n Increase the spacing between the equipment and
receiver.
n Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
n Contact your BERNINA dealer or an experienced
radio/television technician.
Any change or modification to the device that has not
been expressly approved by BERNINA can invalidate the
electromagnetic compatibility (EMC) and result in the
revocation of the operating license for this device.
To Next Page
Loading...
