Bernina 990 - Page 6

Safety
SAFETY INSTRUCTIONS 6
►
Always use an original BERNINA Stitch
Plate.
An incorrect stitch plate can result in
needle breakage.
►
Use only straight needles of good quality.
Bent or damaged needles can cause
needle breakage.
►
The machine is double-insulated.
Only use original spare parts. See
instructions for servicing of double-
insulated products.
►
To lubricate the machine, only use oil
recommended by BERNINA.
►
Risk of chemical burns and ingestion. Keep
the battery out of the reach of children.
This machine contains a lithium button cell
battery. If a new or used lithium button
cell battery is swallowed or ingested, this
can cause serious internal injuries and can
be fatal within two hours. The battery
compartment must therefore always be
kept securely closed. If it is not possible to
securely close the battery compartment,
stop using the machine, remove the
battery and keep it out of the reach of
children. If you suspect that batteries have
been swallowed or ingested, consult a
doctor immediately.
Appropriate Use
►
The machine may be used, cleaned and
maintained by children older than eight or
by people with reduced physical, sensory
or mental capabilities or if there is a lack
of experience and knowledge.
Furthermore, these persons must be
supervised while working with the
machine, or they must know the safe
operation of the machine and be aware of
resulting hazards.
►
Children are not allowed to play with the
machine.
Special care should be taken when the
machine is operated by or in the presence
of children.
►
Only use the machine with the supplied
power cable.
USA and Canada only: Do not connect
power plug NEMA 1-15 to circuits
exceeding 150volt-to-ground.
If the machine is to be used in a country
other than the country of origin, obtain a
power cable suitable for this country from
a BERNINA dealer.
►
Only use this machine with the supplied
foot control of type LV-1.
►
Do not insert any objects into the
openings of the machine.
►
Do not place any objects on the foot
control.
►
While sewing, guide the fabric gently.
Pulling and pushing the fabric can cause
needle breakage.
►
Keep fingers away from all moving parts.
Special care is required in the needle area.
►
Only lift the machine by the handle.
►
For activities in the needle area – such as
threading the needle, changing the
needle, threading the looper or changing
the presser foot – switch off the machine.
To switch off, set the power switch to 0.
►
When protective covers are removed,
when the machine is oiled or when other
cleaning and maintenance operations
mentioned in this instruction manual are
carried out, switch off the machine and
disconnect the power plug from the
outlet.
►
Pull the plug out of the outlet by pulling
on the plug. Do not pull on the cable.