Brother CS5055PRW - Attachment of Feed Adjuster Assy; Assembly of Feed Adjuster Assy

3 - 67
Feed and rotary module
Application of Assembly
Application
1 Attachment of Feed adjuster assy
1. Insert the polyester slider 2 and the spring into the shaft of the feed
adjuster assy. 1.
*Key point
• Insert the spring starting with the side having the smaller
spring diameter.
2. Set the feed adjuster assy. 1 to the base plate assy.
Lubricate the feed adjuster shaft with FBK OIL RO
100.
1-2 drops
XC8388***
Apply EPNOC AP (N) 0 to the entire operating
part of the feed adjuster feed regulator slide block.
Bead
XC8387***
S02
2
1
S02
1
S02
Spring
XC2531***
8.8
9.9
5.5
1-1 Assembly of Feed adjuster assy
1. Set the F gear 2 to the feed adjuster 1.
*Key point
• When set it as shown in the right figure, check that the
protrusion 3 of the F gear 2 is the upper side.
2. Attach the spring .
Apply EPNOC AP (N) 0 to the entire operating
surface of the feed adjuster and F gear.
Small amount
XC8387***
S03
1 2
3
S03
S03
15.1
5
Spring
XC2530***