Brother CS5055PRW - Assembly of Rear Cover Assy; Attachment of Base Plate Rubber (Rear Cover Side); Attachment of Cutter Cover Assy; Assembly of Cutter Cover Assy

3 - 43
Main parts
Application of Assembly
Application
1 Assembly of Rear cover assy
1-1 Attachment of Base plate rubber (Rear cover side)
1. Attach the base plate rubber 1 to the rear cover assy..
2. Set the rubber cushion A 2 and the washer plain M 3.5 3 to the rear cover
assy. with the screw 1.
1
Torque
0.39 – 0.78 N·m
1
3 12
Taptite, Pan B
M3.5X12
1-2 Attachment of Cutter cover assy
1. Set the cutter cover assy. 1 to the rear cover assy. with the screw 1.
*Key point
• Check that the rib of the cutter cover assy. 1 engaged with
the groove of the rear cover assy..
1
Torque
0.78 – 1.18 N·m
11
Taptite, Bind B
M4X10
1-2-1 Assembly of Cutter cover assy
1. Set the NT lower thread cutter 2 to the cutter cover 1.
2. Set the cutter holder plate 3 to the cutter cover 1 with the screw 1.
*Key point
• Check that the end of the cutter holder plate 3 engaged with
the positioning groove of the cutter cover 1.
1
Torque
0.59 – 0.78 N·m
1
3
2
3
1 2
1
Screw, Bind
M3X4