Brother CS5055PRW - Motor Belt Tension

4 - 5
Adjustment
Adjustment
Motor belt tension
[Adjustment standard]
The belt deflection must be 3 to 4 mm when pushing the center of the motor belt with a force of 0.98N (100g).
[Adjustment procedure]
1. Remove the front cover.
2. Remove the power supply unit.
3. Loosen the 2 screws (giza tite 5 x 16) of the motor holder.
4. Move the motor holder up and down, to adjust the belt deflection is 3 to 4 mm when pushing the center of the
motor belt with a force of 0.98N (100g).
5. Tighten the 2 screws (giza tite 5 x 16) of the motor holder.
XC2277001 Push-pull gauge (5N)
Motor holder
3 - 4mm
Giza tite 5 x 16
0.98N (100g)