4 - 2
Test Mode Starting test mode/Starting and stopping operation
1. How to start test mode
• Turn on the power while pressing (Reverse/reinforcement stitch button), and press (Stitch selection
key) in the state that continued pressing (Reverse/reinforcement stitch button) within one second, four
beeps sound, and then test mode starts.
*Key point
• In case of models not equipped with the buzzer, beep does not sound.
2. Mode selection
• Press (Stitch selection keys) and select pattern number (mode).
3. Starting and stopping test mode
• Press (Start/stop button).
• In case of models not equipped with (Start/stop button), press down and/or release the foot controller.
Within
one second
To Next Page
Loading...
